SimName.GEO File

* red  words are TACITE's reserved words

Structure :

Internal diameter1
Absolute roughness1
Internal diameter2
Absolute roughness2
Internal diameterN
Absolute roughness1
loop on equipments :

if there are sources or sinks :
Name         Type         Location
if there are valves :
Name         Type         Location        Coefficient        Exponent
if there is an injector :
Name         Type         Injection angle with respect to pipe axis
if there are relief valves :
Name         Type         Location        Hole diameter
if there are pumps :
Name         Type         Location
if there are pigs :
Name         Type         Location        Launcher location
Trap location         Diameter        Length        Weight        Wall friction factor coefficient

end loop

if there are pumps :
loop on pumps :
Nominal rotation velocity        Minimal rot. velocity         Maximal rot. velocity
Maximum pressure drop
Number of stages        Number of stages for results to print
        loop on stages
Input internal diameter        Input external diameter        output external diameter         Angle coefficient
        end loop
end loop


Example :

0.d0         0.2d0     10d-5
1000.0d0      0.25d0       10-5
3000.0d0       0.1d0      10d-6
so1            1       0.d0
si1              2       5000.0d0
rv1             5       15.0d0    0.05d0
valv2         3       4900.0d0    0.9d0    1
wpump     6       1000.0d0
50.d0    0.d0    100.d0
1    1
0.05d0   0.14d0 0.10d0  0.5



Type codes :

1 -> source
2 -> sink
3 -> valve
4 -> injector
5 -> relief valve
6 -> pump
7 -> pig

About Valves : To simulate a linear valve coefficient and exponent have to be set to 1.

About Pumps : The maximum rotation velocity should not exeed 150 rpm.

                                   The pump modul is based on the Poseidon model.

                                   The transient thermal option are not available with a pump.

About Relief Valves : The hole diameter of a relief valve should not exeed the half diameter of the pipe.

About Pigs :  The launcher location has to be on a mesh side but after the second global mesh side.

                               The trap location has to be lower than the pipe length.

                               The pig diamerter has to be lower or equal to the pipe diameter.

                               The pig wall friction factor coefficient can be given equal to 1.

                               No other equipment can be used with a pig.

                               The pig length has to be lower or equal than the length of the shorter cell over 5.